YouSub
Untitled

en English

Untitled English subtitles

0 downloads · 20 lines · added Jul 26, 2015

Report a problem
What's wrong?
Advertisement

English transcript

How to Prepare a Standard EDTA Solution. When converted to a standard solution, EDTA is
a useful chemical compound for titration applications such as determining the metallic content of
various solutions. You will need Chemistry techniques Balance 4 grams purified dihydrate
ethylenediaminetetraacetic acid Desiccator 1L volumetric flask Powder funnel 1L purified
water and stopper (optional). Step 1. Measure 4 grams of purified dihydrate ethylenediaminetetraacetic
acid on the balance and dry at 80 degrees Celsius for one hour before letting it cool
to room temperature in the desiccator. The salt will contain about 0.3 percent moisture
after drying and cooling. Make a note to correct the salt's weight in your calculation of the
molarity of the finished solution. Step 2. Weigh 3.8 grams and transfer it into a volumetric
flask using a powder funnel. Step 3. Rinse the funnel by pouring a small amount of distilled
or deionized water through it before removing the salt. Then add enough extra purified water
to make 700 milliliters. Use a dry, uncontaminated container with a non-glass stopper. Step 4.
Swirl the solution until all of the powder has dissolved. Be patient -- it may take up
to 15 minutes for the solution to be completely dissolved. Step 5. Add more purified water
until it reaches the 1-liter mark, and mix well. Step 6. Calculate the molarity, or molar
concentration, of the solution. The result should be at or very close to 0.01 M. Step
7. Store the solution with a stopper. If you plan to use it for titration, it's good practice
to conduct the experiment while the solution is still fresh. Did you know EDTA was first
used as a medical treatment for heavy metal poisoning in the 1940s, and is still FDA-approved
for that purpose.

Need subtitles from another video?