YouSub
Untitled

en English

Untitled English subtitles

0 downloads · 38 lines · added Sep 25, 2015

Report a problem
What's wrong?
Advertisement

English transcript

Extraction of DNA from fish fins
DNA, or deoxyribonucleic acid, is the hereditary material in humans and almost all other organisms.
Hundreds of thousands of nucleotides are hooked together to form a chain, and two chains are
paired together and twisted into a double helix to form the finished DNA molecule. Many
different methods and technologies are available for the isolation of genomic DNA.
Here, we describe a method for the isolation of PCR-ready genomic DNA from zebra-fish tissues.
Procedure ? Cut a small portion of zebra fish fins and
put it in a mortar. ? Add some 600microlitre of extraction buffer
from ice box to the mortar and make it into a paste.
? Transfer this paste into a new vial. ? Then, keep it in water bath at 37°C for
1 hour for the hydrolysis of tissues and release of DNA.
? Keep it again in water bath at 55°C for another 1 hour. RNA present in the sample
will be damaged. ? Centrifuge it at 5000rpm for 10 minutes.
? Transfer 300 micro litre of the supernatant without disturbing the pellet to a new vial.
? Add 200 micro litres of the reagent: Phenol: Chloroform: Isoamyl alcohol which is in the
ratio 20:24:1 to the vial that contains supernatant. ? Mix it by inverting the vial approximately
five times by hand. ? Centrifuge it at 12,000rpm for 10 minutes.
? We can observe two layers in the tube: a bottom organic and a top aqueous layer.
? Separate the aqueous layer to a fresh vial without disturbing the bottom layer.
? Mix the new reagent: Chloroform: Isoamyl alcohol in the ratio 24: 1. Make sure you,
change the tip of the pipette each time, you take new reagent.
? Mix the contents in the vial again by inverting. ? Centrifuge it for 10 minutes at 12,000rpm.
? Now, the contents of the tube are separated into two layers.
? Transfer the supernatant to the new vial. ? Add 3 molar, 100microlitre of Sodium acetate
to the vial. ? To the same vial add 100microlitre of new
reagent: Ice cold (100%) ethanol kept in an icebox .
? Mix it by inverting the vial slowly. ? Tap the tip of the vial.
? Now, the DNA strands will be visible when seen against light.
? Centrifuge it for 10 minutes at 10000 rpm. ? Decant the ethanol or pour off the supernatant
to get the pellet. ? Wash the pellet with 70% ethanol using a
pipette. ? Centrifuge it for 10 minutes at 10,000 rpm.
? Decant the ethanol / supernatant using the pipette.
? Keep the vial at the room temperature for the ethanol to evaporate.
? Then, dry the vial on the blotting paper. ? Once the vial is dried, add 50-100microlitre
of TE buffer . ? ADD 2microlitre of RNAase to the same vial
containing DNA. ? Incubate the vial in water bath for 2 hrs
at about 37°C. ? Load it to the Agarose gel of 0.8% concentrations
and observe the DNA in a transilluminator.

Need subtitles from another video?