Advertisement
English transcript
ASEPTIC TECHNIQUE
Aseptic means "without microorganisms." Aseptic transfer techniques or sterile transfer techniques
are a series of procedures for working with live microorganisms and samples which may
contain infectious microorganisms. These procedures were developed for the protection of the researcher
against infectious agents as well as for the protection of the pure culture of microorganisms
from contaminating agents from the outside environment.
Here, we are going to explain aseptic technique for inoculation of broth culture.
Procedure: Switch on the light and blower and then open
the laminar air flow. Clean the work space.
Turn on the Bunsen burner. Make sure the flame is blue in colour.
Take a wire loop. Heat the inoculation loop with burner. Start
burning the loop horizontally from its base to vertical position till it becomes red hot.
Cool the loop for few seconds . Never waive or touch the sterile agar surface in order
to hasten cooling. Pick up the petri plate from the table and
open the plate only in your hand. Make sure you do not open the plate completely.
Once loop is cooled, pick an isolated colony from the plate.
Take the appropriate sterile broth. Remove the cotton and heat the mouth of the
test tube. Insert the loop and stir it slightly.
Flame the mouth of the test tube once again and close it with the cotton.
Sterilize the loop. Keep this test tube in a shaking incubator
for 24 hrs at about 37°C. The resulting solution is called a broth culture,
which is yellowish in colour.
Aseptic means "without microorganisms." Aseptic transfer techniques or sterile transfer techniques
are a series of procedures for working with live microorganisms and samples which may
contain infectious microorganisms. These procedures were developed for the protection of the researcher
against infectious agents as well as for the protection of the pure culture of microorganisms
from contaminating agents from the outside environment.
Here, we are going to explain aseptic technique for inoculation of broth culture.
Procedure: Switch on the light and blower and then open
the laminar air flow. Clean the work space.
Turn on the Bunsen burner. Make sure the flame is blue in colour.
Take a wire loop. Heat the inoculation loop with burner. Start
burning the loop horizontally from its base to vertical position till it becomes red hot.
Cool the loop for few seconds . Never waive or touch the sterile agar surface in order
to hasten cooling. Pick up the petri plate from the table and
open the plate only in your hand. Make sure you do not open the plate completely.
Once loop is cooled, pick an isolated colony from the plate.
Take the appropriate sterile broth. Remove the cotton and heat the mouth of the
test tube. Insert the loop and stir it slightly.
Flame the mouth of the test tube once again and close it with the cotton.
Sterilize the loop. Keep this test tube in a shaking incubator
for 24 hrs at about 37°C. The resulting solution is called a broth culture,
which is yellowish in colour.