YouSub
Untitled

en English

Untitled English subtitles

0 downloads · 38 lines · added Sep 25, 2015

Report a problem
What's wrong?
Advertisement

English transcript

Hot Shot Method of DNA Extraction
Introduction
DNA, the building block of life is the genetic material for most living organisms and it
contains information that is crucial for heredity. It is employed in genetic analysis especially
in those important in scientific, medical, or forensic purposes. Methods involved in
isolation of DNA have reagents and techniques to lyse the membrane, concentrate the DNA
and remove the contaminants. Conventional methods like Proteinase K though ensures pure
preparation of DNA, they are cumbersome. But as many DNA based analytical techniques demand
pure preparations of DNA the conventional method is opted. But for certain techniques
like the PCR the requirement is for quicker methods and thus partially pure material is
sufficed. Hot shot method is one such method and is a source of PCR-ready DNA preparation.
This method uses a few reagents such as Hot NaOH, and Tris HCl in order to extract DNA
from the cell. The cell debris is removed by a round of centrifugation. In conclusion,
this method is rapid, reliable, and cost-efficient for the isolation of PCR-ready DNA.
Materials Required Fish fin
Spatula 50 milli Molar NaOH solution
1Molar Tris-HCl Micropipette
Pipette tips 5ml Microfuge tubes
Morter and pestle Water bath
Floater Syringe
Centrifuge 4 degree freezer
-20 degree freezer Discarding beaker
Procedure Ensure all required materials are at hand.
Place the fish fin in the mortar. Grind the fin using the pestle.
Take 100 µl NaOH solutions in a pipette and pour it into a vial.
Transfer the ground contents into the vial using a spatula and mix the contents well.
Take a syringe and inject it into the vial. Keep the vial on the floater and place this
in a water bath of 95oC for 20 minutes. Take out the vial from the water bath.
Remove the syringe from the vial and keep the vial in an ice box for 5 minutes.
Take a pipette and adjust it to 10 µl and take 10 µl 1Molar Tris-HCl from the bottle.
Add it in to the vial, mix the contents well and close the vial.
Open the Centrifuge and place the vial in it.
Another vial with equal volume of water is kept in the centrifuge for balancing it.
Centrifuge these at 5000rpm for 10 minutes. Take out both the vial from the centrifuge.
Take a pipette and pipette out the supernatant from the vial.
Transfer the supernatant from the pipette into another vial.
For long term storage, place the vial in a cryo box and keep it in a -20 degree freezer.
For short term storage, place the cryo box(Pronounciation) with vial keep it in 4 degree freezer.

Need subtitles from another video?